Please choose your operating system below to view the pairing guide.

     

Laser Model: (Current generation; Has "L" after model number)
Steady Blue - Mouse in Discoverable Mode / Searching for Pairing Host or Exhausted Battery
Flashing Blue - Searching for Pairing Host OR Low Battery
Flashing Red & Green (for 3-4 seconds) - Preparing to Charge
Flashing Red & Green (continuously) - Check Battery Orientation or Defective Cell
Steady Red - Charging
Steady Green - Charge Complete

Optical Model: (Previous generation)
Steady Blue - Mouse in Discoverable Mode / Searching for Pairing Host
Steady Red - Charging
Flashing Red - No Battery Detected or Installed Incorrectly
Steady Green - Charge Complete
Flashing Green - Unable to Charge: Defective Cell(s) or USB Cable, Insufficient USB Power
Flashing Red & Green - No USB Power Detected- Power Mouse OFF & Reconnect USB Cable

Switch mouse OFF - the power switch for the BT600 is a push button located at the top, center.
Connect USB cable to mouse - scroll wheel should flash green and red for 2-3 seconds, then illuminate steady red to indicate charging.

You can NOW switch the mouse ON and use it while it's charging.
When the scroll wheel illuminates steady green, charging is complete, and cable can be disconnected without switching the mouse off.

Place power switch in the ON position.
Remove batteries for 30 seconds (leave power switch in ON position).
Reinstall batteries and test mouse.